Magic Clip Charging Dock

CABLE NOT INCLUDED!!!!!

This is an original design of mine for the Cordless Wahl Magic clip, the Magic Clip Charging Dock. Multiple colors to choose and more to come. The clippers original cable fits from the side and it will set in place by pulling it from the bottom. The cable has to be pulled from the bottom in the right orientation.

I left the bottom as flat as possible for the flexibility of adding velcro, magnets, double sided tape or glue to the bottom of the dock to keep it in place. Note that depending on the cable and the expansion of plastic on the clipper and the cable , your clippers may just come in and out with ease. I have noticed that a little resistance is needed to keep the dock on the table when you grab the clippers out of the dock. I found that small velcro tabs worked the best.

This Charging Dock is made with PETG plastic (Polyethylene Terephthalate Glycol) which makes the part very strong and resistant to heat (The glass transition temperature is the temperature where the material starts to soften and it is 185F for PETG) The surface will have some aesthetic imperfections just like any other 3D printed Part. These imperfections do not affect the function of the part.

If you have any other questions please feel free to contact me directly at Figxter3d@gmail.com .

3D Printed Parts Disclaimer

All 3D Printed products are made by the Plastic Extrusion method. This means that plastic is heated and layered upon itself to build the final part. As a result the resulting completed parts are not as strong as normal injection molded plastics. In addition the point at which the plastic becomes pliable is a lot less than regular plastics. It is not recommended to use 3D Printed parts for use in confined spaces that are subject to high temperatures as the parts may distort. Examples include; inside a hot car, in direct sunlight for prolonged periods or any other area that can potentially exceed 150 F Degrees and above. We are not responsible for any damage as a result of high heat exposure. In an effort to mitigate this Figxter ONLY provides products made with high temperature PETG plastics when strength and high temperature is needed. We determined earlier on that PLA turned out NOT to be suitable for some applications.

All Parts are made to order and 3D printed in strong PETG unless otherwise stated. Please allow 24 hours for the production process.

Note:

3D Printed Parts are not like Injection Molded Parts. The surface will show extrusion rings, artifacts, blemishes and other signs of plastic extrusion. This will occur with any 3D Printed parts using the FDM method of printing as we do. Slanted and curved vertical (Z Axis) surfaces will show more extrusions, artifacts, blemishes and signs of plastic extrusion than flatter parts. This in no way deters from the parts functionality. All parts are inspected prior to shipment.